u1-fixpack

U1 Fix Pack

Firmware fixes for the Snapmaker U1, each one reproduced, patched and regression-tested on Snapmaker’s own firmware code (Snapmaker/u1-klipper, 2.0.0 and 2.1.0) with no printer on the desk.

Download the latest release · Source and full write-up · Forum topic

What is fixed

What U1 owners see Patch Proof on the real firmware
Skip an object, then pause or change tool: Resume stops with “Move out of range”, or the prime in the chute drags the head across the bed (#22) 0022-exclude-object-manual-move.patch Two prints a U1 owner lost on stock 2.0.0.205, replayed unmodified: stock reproduces both faults, patched prints both to the end (evidence)
After a skipped object the nozzle travels over finished parts almost at print height 0022b-exclude-object-lift-before-travel.patch 8 such travels on the owner’s file, 0 with the patch (evidence); offline only, not printed
Part cooling fan switches 2 to 4 s before the toolhead reaches the M106/M107 (#18) 0018-fan-gcode-motion-sync.patch 4366 ms early on stock, 10 ms after the step with the patch (evidence)
Runout and resume replace the head’s measured flow calibration with the default (#8) 0008-runout-resume-keeps-flow-k.patch 0.023951 becomes 0.020000 on stock, kept with the patch (evidence)

Every patch has a test that fails on the shipped firmware, passes with the patch, and fails again on each deliberately wrong version of the patch. CI runs all of it on 2.0.0 and 2.1.0.

Use it

From the release zip, on a u1-klipper checkout of 2.0.0 (93cb12f) or 2.1.0 (7ac453b):

git apply patches/0022-exclude-object-manual-move.patch
git apply patches/0022b-exclude-object-lift-before-travel.patch
git apply patches/0018-fan-gcode-motion-sync.patch
git apply patches/0008-runout-resume-keeps-flow-k.patch

0022b goes on top of 0022; the others are independent. On stock firmware, with no patch, tools/fan_m400.py is a slicer post-processing script that brings the fan from 4566 ms early to 240 ms early.

Limits

Klipper batch mode has no physics and no sensors. Each patch still needs a run on a physical U1: if you try one, please say how it went in the forum topic or in an issue, either way. Built with AI coding assistance. GPL-3.0, the same license as u1-klipper.